Halloween Charm Ornaments Embroidery Project

Hoop solvy making sure that it is hooped very tightly.

Once the design is done embroidering remove from the machine and trim the excess solvy around the outside of the design.

Then add hot/warm water to your container. The water should be high enough in the bowl so that the entire lace heart will be submerged.

Place your lace design inside the container. Let the design soak for about 10-15 minutes. This will remove the solvy from the water and place on paper towel to dry making sure that it is flat.

Use your pliers to slightly open one 4mm jump ring.

Place the fishhook earring onto the ring also.

Here you have the completed earring.

Place the necklace clasp onto the necklace near one end and tie it off with a couple of knots.

Now that you have the beads on your necklace attach the other side on the clasp and tie it on. Close the clasp. Now stretch out the necklace and tape the clasp down to your table and tape the embroidery design down, pulling the necklace tight.

With a ruler beside the necklace position the beads where you would like them. You can use the ruler to make sure that the beads are in the same position on both sides.

Use your jewelry glue to secure a bead on each side of the embroidery design to keep it in place. Then glue each bead to the necklace on each side. After you have completed this step let the glue dry according to the instructions on the package.

You can purchase Halloween Trees at most craft stores or you can make your own.