Applique Easter Bunny Pillow Cover Embroidery Project

Gather all supplies and review instructions before beginning. 

Load design into your machine. Edit and resize design to approximately 6” x 7”.
Refer to your machine’s instructions on how to resize. 

Quarter fold your front cut cotton piece by folding in half and then half again. Iron or finger tip press. This will create a pressed cross hair. . Using your temporary adhesive spray, lightly spray your cut cotton batting and place your top cut piece on top with right side up. Finger press to secure. Trim excess cotton batting to size.  Iron press if needed.  Trim excess batting from all sides leaving approximately 1” out from all side edges of cotton fabric. Cut a piece of stabilizer to fit and place underneath the cotton batting.  Hoop all three layers matching up axis lines ( using creased cross hair as your guide) to markings on your hoop.

Attach hoop to machine. Confirm center needle placement. Refer to embroidery design thread color chart. Begin the embroidering process.  Embroidering complete. Remove hoop. Cut and trim all jump stitches and loose thread ends. Front and back.

INSTALLING ZIPPER
Zipper will be attached to the bottom edge of front pillow cover. Turn down ¼” on one end of each 2” x 3” pieces. Straight stitch in place. Using the bottom edge of pillow cover as a guide apply one to each end of zipper. Refer to picture. Stitch in place. 

Trim excess from sides of zipper. 

Center zipper to bottom edge of front pillow cover with right sides together. Stitch using 1/8”- 1/4" seam allowance. Fold over to right side and top stitch close to folded edge.

Place pillow back atop front matching bottom edge to zipper edge. Attach zipper in the same manner as in step #8.

Right sides together. Unzip zipper halfway leaving an opening to turn right side out. Match up side edges and bottom edge. Pin in place. Stitch using ½” seam allowance both sides and top of pillow cover. Carefully stitch through zipper teeth. If needed serge or zigzag top and sides.

Turn right side out through zipper opening. Push out corners. Insert pillow form. And your are done! Great job!