Wedding Table Number Hoops Embroidery Project

Gather your materials and review instructions before beginning.

Cut one piece stabilizer and organza to fit your machine's  hoop.

Hoop both stabilizer and organza.

Attach hoop to your machine.

Begin embroidering.  Enjoy the embroidering process!

When design is complete.  Remove hoop from machine and clip all loose thread ends and jump stitches. Front and back.

Remove stabilizer.   (Tip:  Soak in water to dissolve any remaining hard to remove stabilizer then blot the fabric with paper towel and let air dry.  Press with top cloth on low setting if needed)

Center your design onto smaller ring of wooden embroidery hoop.  Looses the tightening device at top on the larger ring and position larger ring over smaller ring.  Pushing down to hold fabric taut and in place.  Once centered, tighten using tightening device. 

Trim excess organza as shown in picture.

Add your ribbon to top at the tightening device by tying into a bow.  Your table number hoop is now complete!  Repeat steps when making numerous table number hoops.   Congratulations and Best Wishes!